Dell PowerConnect B-RX Configuration Manual page 125

NOTE
The copy options require you to explicitly specify the flash card. Therefore, you can perform a copy
regardless of the flash card that currently has the management focus.
Copying files from one flash card to the other
To copy a file from one flash card to the other, enter the following command.
BigIron RX# copy slot1 slot2 sales.cfg
Syntax: copy <from-card> <to-card> [/<from-dir-path>/]<from-name>
For the <from-card> and <to-card> parameters, you can specify slot1 or slot2.
The command shown in the example copies a file from the flash card in slot 1 to the flash card in
slot 2. In this case, the software uses the same name for the original file and for the copy.
Optionally, you can specify a different file name for the copy.
Copying files between a flash card and flash memory
To copy a file from a flash card to the primary area in flash memory, enter a command such as the
following.
BigIron RX# copy slot1 flash nmpr02200.bin primary
Syntax: copy slot1 | slot2 flash [/<from-dir-path>/]<from-name> monitor | primary | secondary
To copy a file from flash memory to a flash card, enter a command such as the following.
BigIron RX# copy flash slot2 nmpr02200.bin primary
Syntax: copy flash slot1 | slot2 <source-name> monitor | primary | secondary | startup-config
The command in this example copies a RX Series IronWare image file from the primary area in flash
memory onto the flash card in slot 2. In this case, the software uses the same name for the source
file and for the destination file. Optionally, you can specify a different file name for the destination
file.
Copying software images between active and standby management modules
To copy the monitor image from flash memory of the active management module to flash memory
of the standby module, enter the following command.
BigIron RX# copy flash flash monitor standby
Syntax: copy flash flash monitor standby
To copy the RX Series IronWare image from the secondary location in the active management
module's flash memory to the primary location in the active module's flash memory, enter the
following command.
BigIron RX# copy flash flash primary
Syntax: copy flash flash primary [standby]
BigIron RX Series Configuration Guide
53-1001810-01
Flash memory and PCMCIA flash card file management commands
[/<to-dir-path>/][<to-name>]
[<dest-name>]
3
53