Configuring Basic Parameters
In this chapter
This chapter describes how to configure basic system parameters.
The device is configured with default parameters to allow you to begin using the basic features of
the system immediately. However, many advanced features, such as VLANs or routing protocols for
the router, must first be enabled at the system (global) level before they can be configured.
You can find system level parameters at the Global CONFIG level of the CLI.
NOTE
For information about the Syslog buffer and messages, refer to
NOTE
Before assigning or modifying any router parameters, you must assign the IP subnet (interface)
addresses for each port.
BigIron RX Series Configuration Guide
53-1001810-01
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Appendix A, "Using
Syslog".
Chapter
5
113