Displaying And Modifying System Parameter Default Settings - Dell PowerConnect B-RX Configuration Manual

•
•
•
•
•
By default, IP routing is enabled on the device. All other protocols are disabled, so you must enable
them to configure and use them.
NOTE
The following protocols require a system reset before the protocol will be active on the system: PIM,
DVMRP, RIP, FSRP. To reset a system, enter the reload command at the privileged level of the CLI.
To enable a protocol on a device, enter router at the global CONFIG level, followed by the protocol to
be enabled. The following example shows how to enable OSPF.
BigIron RX(config)# router ospf
BigIron RX(config)# end
BigIron RX# write memory
BigIron RX# reload
Syntax: router bgp | dvmrp | ospf | pim | rip | vrrp | vrrpe

Displaying and modifying system parameter default settings

The device has default table sizes for the following parameters. The table sizes determine the
maximum number of entries the tables can hold. You can adjust individual table sizes to
accommodate your configuration needs:
•
•
•
•
•
•
•
•
•
•
The tables you can configure as well the defaults and valid ranges for each table differ depending
on the device you are configuring.
NOTE
If you increase the number of subnet addresses you can configure on each port to a higher amount,
you might also need to increase the total number of subnets that you can configure on the device.
BigIron RX Series Configuration Guide
53-1001810-01

Displaying and modifying system parameter default settings

OSPF
PIM
RIP
VRRP
VRRPE
MAC address entries
Layer 2 Port VLANs supported on a system
Layer 3 Protocol VLANs supported on a system
Layer 4 sessions supported
IP cache size
ARP entries
IP routes
IP route filters
IP subnets per port and per device
Static routes
5
127