Dell PowerConnect B-RX Configuration Manual page 59

Bigiron rx series configuration guide v02.7.02
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

TABLE 12
Enhancement
Enhanced Digital
Optical Monitoring
Re-distributing CAM
Allocations
Enhanced SFM
(power-off)
command
Enhanced
speed-duplex
command
Layer 2 enhancements
TABLE 13
Enhancement
Flow based MAC Learning
VSRP Slow-Start
802.1s Multiple Spanning Tree
Protocol (MSTP)
BigIron RX Series Configuration Guide
53-1001810-01
System enhancements (Continued)
Description
You can configure the BigIron RX to monitor XFPs and SFPs in
the system either globally or by specified port.
In releases prior to 02.3.00, CAM partitioning was not
configurable. Starting in BigIron RX software release 02.3.00,
you can specify the CAM assigned to each of the CAM entry
types globally.
You can disable power to a specified switch fabric module and
then reenable it.
In this release, the speed-duplex command has been
enhanced to include the master and slave parameters.
Layer 2 enhancements
Description
In this release, the cpu-flooding unknown-unicast
command that disables hardware flooding of
unknown unicast on every VLAN has been added.
This will allow MAC learning only where necessary
and at a system level to allow more than 16k MACs.
This feature allows for a hold down time before the
backup returns ownership to the master after the
link is seen.
With this release, you can configure multiple STP
instances using MSTP protocol, as defined in IEEE
802.1s
See...
Book: Brocade BigIron RX
Series Installation Guide
Chapter: Connecting a
BigIron RX Series Switch
to a Network Device
Section: Enhanced Digital
Optical Monitoring
Book: BigIron RX Series
Configuration Guide
Chapter:
"Configuring
Basic Parameters"
Section:
"Re-distributing
CAM allocations"
Book: Brocade BigIron RX
Series Installation Guide
Chapter: Managing the
BigIron RX Series Chassis
and Modules
Section: Disabling and
Reenabling Power to the
Switch Fabric Modules
Book: BigIron RX Series
Configuration Guide
Chapter:
"Configuring
Interface Parameters"
Section:"Speed/Duplex
negotiation"
See...
Book: BigIron RX Series
Configuration Guide
Chapter:
"VLANs"
Section:
"Flow based
MAC learning"
Book: BigIron RX Series
Configuration Guide
Chapter:
"Virtual Switch
Redundancy Protocol
(VSRP)"
Section:"VSRP slow
start"
Book: BigIron RX Series
Configuration Guide
Chapter:
"Multiple
Spanning Tree Protocol
(MSTP) 802.1s"
lix

Advertisement

Table of Contents
loading

This manual is also suitable for:

Brocade dcx-4sBrocade dcx

Table of Contents