Dell PowerConnect B-RX Configuration Manual page 145

NOTE
If you forget your Super User level password, refer to
Augmenting management privilege levels
Each management privilege level provides access to specific areas of the CLI by default:
•
•
•
You can grant additional access to a privilege level on an individual command basis. To grant the
additional access, you specify the privilege level you are enhancing, the CLI level that contains the
command, and the individual command.
NOTE
This feature applies only to management privilege levels on the CLI. You cannot augment
management access levels for the Web Management Interface.
To enhance the Port Configuration privilege level so users also can enter IP commands at the
global CONFIG level.
BigIron RX(config)# privilege configure level 4 ip
In this command, configure specifies that the enhanced access is for a command at the global
CONFIG level of the CLI. The level 4 parameter indicates that the enhanced access is for
management privilege level 4 (Port Configuration). All users with Port Configuration privileges will
have the enhanced access. The ip parameter indicates that the enhanced access is for the IP
commands. Users who log in with valid Port Configuration level user names and passwords can
enter commands that begin with "ip" at the global CONFIG level.
Syntax: [no] privilege <cli-level> level <privilege-level> <command-string>
The
•
•
•
•
•
•
•
•
•
•
•
BigIron RX Series Configuration Guide
53-1001810-01
Super User level provides access to all commands and displays.
Port Configuration level gives access to:
•
The User EXEC and Privileged EXEC levels
•
The port-specific parts of the CONFIG level
•
All interface configuration levels
Read Only level gives access to:
•
The User EXEC and Privileged EXEC levels
parameter specifies the CLI level and can be one of the following values:
<cli-level>
exec – EXEC level; for example, BigIron RX
configure – CONFIG level; for example, BigIron RX
interface – Interface level; for example, BigIron RX
virtual-interface – Virtual-interface level; for example, BigIron RX
rip-router – RIP router level; for example, BigIron RX
ospf-router – OSPF router level; for example, BigIron RX
bgp-router – BGP4 router level; for example, BigIron RX
port-vlan – Port-based VLAN level; for example, BigIron RX
protocol-vlan – Protocol-based VLAN level
dot1x
loopback-interface
Setting passwords
"Recovering from a lost password"
or BigIron RX
> #
(config)#
(config-if-e10000-6)#
(config-vif-6)#
(config-rip-router)#
(config-ospf-router)#
(config-bgp-router)#
(config-vlan)#
4
on page 74.
73