Dell PowerConnect B-RX Configuration Manual page 54

TABLE 10
Enhancement
New show OSPF neighbor by
area command
Track IP route time in show
command
Compare MED for internal BGP
route with empty as-path
OSPF Default Network Route
IPv6 Default Route ECMP
IPv6 Tunneling in Hardware
IPv6 Load Sharing over ECMP
and Trunks
Directly Attached Host
Resource Allocation
liv
Summary of enhancements in release 02.4.00 (Continued)
Description
This feature allows OSPF to display the OSPF
neighbors existing in a particular area.
The show ip route command has been enhanced to
include the elapse time since an IP route was
installed.
This new BGP command directs iBGP to take the
MED value into consideration even if the route has
an empty as-path path attribute.
This feature enables the device to use default route
(0.0.0.0/0) to a resolve static OSPF route.
Note:This differs from the default behavior in
previous versions of Multi-Service IronWare
software.
This feature allows for load distribution of traffic
among the available IPv6 default route next-hops.
Manual configuration of IPv6 to IPv4 tunnels is now
supported in this release. These tunnels will be
installed into the hardware route table and tunnel
encapsulation and decapsulation is done in
hardware.
When the device receives traffic for a destination,
and the IPv6 route table contains multiple,
equal-cost paths to that destination, the packets
are load balanced between multiple next-hops
including member ports of a trunk.
The CAM allocations can be re-distributed using the
cam-partition next-hop command.
See page
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring
OSPF Version 2 (IPv4)"
Section: "Displaying OSPF
neighbor information"
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring IP"
Section: "Displaying the IP
route table"
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring
BGP4 (IPv4 and IPv6)"
Section: "Configuring the
BigIron RX to always
compare Multi-Exit
Discriminators (MEDs)"
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring
OSPF Version 2 (IPv4)"
Section: "Configuring a
default network route"
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring
Basic IPv6 Connectivity"
Section: "ECMP load
sharing for IPv6"
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring IP"
Section:"IPv6 over IPv4
tunnels in hardware"
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring
Basic IPv6 Connectivity"
Section: "ECMP load
sharing for IPv6"
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring
Basic Parameters"
Section: "Re-distributing
CAM allocations"
BigIron RX Series Configuration Guide
53-1001810-01