Dell PowerConnect B-RX Configuration Manual page 52

TABLE 8
Enhancement
Multicast
Changes to the copy tftp
Image command
New MIB Objects
Summary of enhancements and configuration notes in patch release
02.4.00c
TABLE 9
Enhancement
ACL Based RP assignment
Route Selection Precedence
for Multicast
lii
Summary of enhancements in release 02.5.00 (Continued)
Description
Starting release 02.5.00, low priority multicast
traffic is rate-limited to 1.8 Gbps per packet
processor.
In Release 02.5.00 of the Multi-Service IronWare
software, new option have been added to the copy
tftp image command to enable the user to upgrade
the boot, monitor, and MBRIDGE only when
needed.
The following MIB objects have been added to the
snIfStpTable:
•
snIfStpPortRole
•
snIfStpBPDUTransmitted
•
snIfStpBPDUReceived
•
snIfRstpConfigBPDUReceived
•
snIfRstpTCNBPDUReceived
•
snIfRstpConfigBPDUTransmitted
•
snIfRstpTCNBPDUTransmitted
Summary of enhancements in release 02.4.00c
Description
The rp-address command has been enhanced to
allow multiple static RP configurations.
In patch 02.4.00c, the route-precedence command
allows the user to specify a precedence table that
dictates how routes are selected for multicast.
See page
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring
Quality of Service"
Section: "Configuring
multicast traffic
engineering"
Book: Release Notes for
device – Multi-Service
IronWare Software Release
02.5.00.
Book: MIB Reference
Chapter: Interfaces
Section: Port STP
Configuration Groups
See page
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring IP
Multicast Protocols"
Section: "ACL based RP
assignment"
Book: BigIron RX Series
Configuration Guide
Chapter: "Configuring IP
Multicast Protocols"
Section:"Route selection
precedence for multicast"
BigIron RX Series Configuration Guide
53-1001810-01