Lldp Dot3 Tlvs Settings - D-Link DGS-1250 Series Reference Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide

LLDP Dot3 TLVs Settings

The LLDP Dot3 TLVs Settings page is used to enable or disable outbound LLDP advertisements for IEEE 802.3
organizationally unique TLVs.
To view the following window, click L2 Features > LLDP > LLDP Dot3 TLVs Settings, as shown below:
The fields that can be configured are described below:
Parameter
From Port - To Port
MAC/PHY
Configuration/Status
Link Aggregation
Maximum Frame Size
Power Via MDI
Click the Apply button to accept the changes made.
Figure 5-62 LLDP Dot3 TLVs Settings Window
Description
Select the appropriate port range used for the configuration here.
Select this option to enable or disable the MAC/PHY Configuration/Status TLV to
send. The MAC/PHY Configuration/Status TLV is an optional TLV that identifies
(1) the duplex and bit-rate capability of the sending IEEE 802.3 LAN node, and (2)
the current duplex and bit-rate settings of the sending IEEE 802.3 LAN node.
Select this option to enable or disable the Link Aggregation TLV to send. The Link
Aggregation TLV indicates contains the following information. Whether the link is
capable of being aggregated, whether the link is currently in an aggregation, and
the aggregated port channel ID of the port. If the port is not aggregated, then the
ID is 0.
Select this option to enable or disable the Maximum Frame Size TLV to send. The
Maximum Frame Size TLV indicates the maximum frame size capability of the
implemented MAC and PHY.
Select this option to enable or disable the power via MDI TLV to send. IEEE 802.3
PMD implementations allow power to be supplied over the link for connected non-
powered systems. The Power Via MDI TLV allows network management to
advertise and discover the MDI power support capabilities of the sending IEEE
802.3 LAN station.
117