Show Telnetcon; Secure Shell (Ssh) Command; Ip Ssh; Ip Ssh Protocol - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference

show telnetcon

This command displays the current inbound Telnet settings. In other words, these settings
apply to Telnet connections initiated from a remote system to the switch.
Format
Modes
Remote Connection Login Timeout (minutes) This object indicates the number of minutes
Maximum Number of Remote Connection Sessions This object indicates the number of
Allow New Telnet Sessions New Telnet sessions will not be allowed when this field is set to

Secure Shell (SSH) Command

This section describes the commands you use to configure SSH access to the switch. Use SSH
to access the switch from a remote management host.
NOTE:

ip ssh

Use this command to enable SSH access to the system.
Default
Format
Mode
no ip ssh
Use this command to disable SSH access to the system.
Format
Mode

ip ssh protocol

This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1),
SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
Default
Format
Mode
302 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
show telnetcon
Privileged EXEC
User EXEC
a remote connection session is allowed to remain inactive before being logged
off. May be specified as a number from 1 to 160. The factory default is 5.
simultaneous remote connection sessions allowed. The factory default is 5.
no. The factory default value is yes.
The system allows a maximum of 5 SSH sessions.
disabled
ip ssh
Privileged EXEC
no ip ssh
Privileged EXEC
1 and 2
ip ssh protocol [1] [2]
Privileged EXEC