Ip Routing - Dell Networking 7048 Reference Manual

Command Mode
Global Configuration mode
User Guidelines
Lower route distance values are preferred when determining the best route.
Example
The following example sets the default route metric to 80.
console(config)#ip route distance 80

ip routing

Use the ip routing command in Global Configuration mode to globally
enable IPv4 routing on the router. To disable IPv4 routing globally, use the no
form of the command.
Syntax
ip routing
no ip routing
Default Configuration
Disabled is the default configuration.
Command Mode
Global Configuration mode
User Guidelines
Use the show ip brief command to determine if routing is enabled or disabled.
Example
The following example enables IPv4 and IPv6 routing for VLAN 15
console(config)#ip routing
1016
IP Routing Commands