Example
console(config-if-vlan3)#ipv6 mld last-member-query-count 5
ipv6 mld last-member-query-interval
The ipv6 mld last-member-query-interval command sets the last member
query interval for the MLD interface, which is the value of the maximum
response time parameter in the group-specific queries sent out of this
interface. Use the "no" form of this command to set the last member query
interval to the default.
Syntax
ipv6 mld last-member-query-interval
no ipv6 mld last-member-query-interval
last-member-query-interval — The last member query interval (Range:
•
0–65535 milliseconds).
Default Configuration
The default last member query interval is 1 second.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-interval 5000
ipv6 mld-proxy
Use the ipv6 mld-proxy command to enable MLD Proxy on the router. To
enable MLD Proxy on the router, you must also enable multicast forwarding.
Also, ensure that there are no other multicast routing protocols enabled on
the router. Use the "no" form of this command to disable MLD Proxy.
1064
IPv6 Routing Commands
last-member-query-interval