Storm-Control Broadcast - Dell Networking 7048 Reference Manual

support all speeds, even if they are available in the command. Entering an
unsupported speed will produce the following error message An invalid
interface has been used for this function. Fiber ports do
not support auto-negotiation. Both ends of fiber connections must be set to
full-duplex and the same speed.
Example
The following example configures the speed operation of Ethernet port 1/0/5
to advertise 100-Mbps operation only.
console(config)#interface gigabitethernet 1/0/5
console(config-if)#speed 100

storm-control broadcast

Use the storm-control broadcast command in Interface Configuration mode
to enable broadcast storm recovery mode for a specific interface. If the mode
is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold,
the traffic will be dropped. Therefore, the rate of broadcast traffic will be
limited to the configured threshold.
Syntax
storm-control broadcast [level |
no storm-control broadcast
• level— The configured rate as a percentage of link-speed.
rate — The configured rate in kilobits per second (kbps). (Range: 0-100)
•
Default Configuration
The default value is 5.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
rate
]
Ethernet Configuration Commands
439