Ipv6 Dhcp Server - Dell Networking 7048 Reference Manual

Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel) mode
User Guidelines
relay-address
If is an IPv6 global address, then
relay-address
If is a link-local or multicast address, then
required. Finally, a value for
relay-interface
must be specified and the DHCPV6-ALLAGENTS multicast
address (i.e. FF02::1:2) is used to relay DHCPv6 messages to the relay server.
An IP interface (VLAN) can be configured in DHCP relay mode or DHCP
server mode. Configuring an interface in DHCP relay mode overwrites the
DHCP server mode and vice-versa.
An IP interface configured in relay mode cannot be configured as a DHCP
client (ip address dhcp).
Example
The following example configures VLAN 15 for DHCPv6 relay functionality.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 dhcp relay destination 2020:1::1

ipv6 dhcp server

Use the ipv6 dhcp server command in Interface Configuration mode to
configure DHCPv6 server functionality on an interface. For a particular
interface DHCPv6 server and DHCPv6 relay functions are mutually exclusive.
Syntax
ipv6 dhcp server
pool-name — The name of the DHCPv6 pool containing stateless and/or
•
prefix delegation parameters
• rapid-commit — Is an option that allows for an abbreviated exchange
between the client and server.
relay-address
pool-name
[rapid-commit] [preference
relay-interface
relay-interface
is not specified, then a value for
pref-value
DHCPv6 Commands
is not required.
is
]
939