Ipv6 Pim Rp-Candidate - Dell Networking 7048 Reference Manual

Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim rp-address
2001:db8:85a3:0:0:8a2e:370:7334 ffe8::0 /16 override

ipv6 pim rp-candidate

Use the ipv6 pim rp-candidate command to configure the router to advertise
itself to the bootstrap router (BSR) as a PIM candidate Rendezvous Point
(RP) for a specific multicast group range. Use the no form of this command
to return to the default configuration.
Syntax
ipv6 pim rp-candidate vlan {
interval }
]
no ipv6 pim rp-candidate vlan {
Parameter Description
Parameter
vlan-id
group-address
group-mask
interval
Default Configuration
None - The router does not advertise itself as an RP candidate by default.
vlan-id group-address group-mask
vlan-id group-address group-mask}
Description
A valid VLAN identifier with multicast routing enabled.
A valid Multicast group address.
A mask indicating the range of multicast groups for which the
router should advertise itself as an RP-candidate.
(Optional) Indicates the RP candidate advertisement interval.
The range is from 1 to 16383 seconds. The default value is 60
seconds.
[interval
IPv6 PIM Commands
1045