Protocol Vlan Group All - Dell Networking 7048 Reference Manual

Syntax
protocol vlan group
no protocol vlan group
groupid — The protocol-based VLAN group ID, which is automatically
•
generated when you create a protocol-based VLAN group with the vlan
protocol group command. To see the group ID associated with the name
of a protocol group, use the show port protocol all command.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add a physical port interface to the
group ID of "2."
console(config-if-1/0/1)#protocol vlan group 2

protocol vlan group all

Use the protocol vlan group all command in Global Configuration mode to
add all physical interfaces to the protocol-based group identified by
A group may have more than one interface associated with it. Each interface
and protocol combination can be associated with one group only. If adding an
interface to a group causes any conflicts with protocols currently associated
with the group, this command fails and the interface(s) are not added to the
group. Ensure that the referenced VLAN is created prior to the creation of the
protocol-based group except when GVRP is expected to create the VLAN.
To remove all interfaces from this protocol-based group that is identified by
groupid
this , use the no form of the command
816
VLAN Commands
groupid
groupid
groupid
.