Dot1X Timeout Guest-Vlan-Period - Dell Networking 7048 Reference Manual

Example
The following example enables 802.1x globally.
console(config)# dot1x system-auth-control monitor

dot1x timeout guest-vlan-period

Use the dot1x timeout guest-vlan-period command in Interface
Configuration mode to set the number of seconds that the switch waits
before authorizing the client if the client is a dot1x unaware client. Use the
no form of the command to return the timeout to the default value.
Syntax
seconds
dot1x timeout guest-vlan-period
no dot1x timeout guest-vlan-period
seconds —
Time in seconds that the switch waits before authorizing the
client if the client is a dot1x unaware client.
Default Configuration
The switch remains in the quiet state for 90 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
It is recommended that the user set the dot1x timeout guest-vlan-period to at
least three times the while timer so that at least three EAP Requests are sent,
before assuming that the client is a dot1x unaware client.
Example
The following example sets the dot1x timeout guest vlan period to 100
seconds.
console(config)# dot1x timeout guest-vlan-period 100
869
802.1x Commands