Interface - Dell Networking 7048 Reference Manual

interface

Use this command to configure parameters for the gigabit Ethernet and ten-
gigabit Ethernet ports, and for port-channels. While in Global Configuration
mode, enter the interface command (with a specific interface). To exit to
Global Configuration mode, enter exit. To return to Privileged EXEC mode,
press Ctrl-Z or enter end.
Additional forms of the interface command enable configuring VLANs, tunnels, the
loopback interface, the out-of-band interface, and ranges of interfaces. See
interface vlan,
Syntax
interface {gigabitethernet unit/slot/port | port-channel
| tengigabitethernet unit/slot/port }
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
Interface Configuration
User Guidelines
It is possible to enter interface configuration mode from global configuration
mode or from interface configuration mode.
Example
The following example enables gigabit port 2 on stack member 1 for
configuration.
console(config)# interface gigabitethernet 1/0/2
console (config-if)#
416
Ethernet Configuration Commands
interface tunnel, interface loopback, and interface
port-channel-number
range.