Clear Counters; Commands In This Chapter - Dell Networking 7048 Reference Manual

On a storm control enabled interface, if the ingress rate of that type of packet
(L2 broadcast, multicast, or unicast) is greater than the configured threshold
level (as a percentage of port speed or as an absolute packets-per-second rate),
the switch forwarding-plane discards the excess traffic.
The speed and
negotiation. If either speed or duplex is set to something other than auto,
auto-negotiation is disabled on the interface. Auto-negotiation will link at the
highest possible speed supported on the interface and prefers full duplex over
half duplex.

Commands in this Chapter

This chapter explains the following commands:

clear counters

description
duplex
flowcontrol
interface
interface range
mtu
show interfaces advertise
clear counters
Use the clear counters command in Privileged EXEC mode to clear statistics
on an interface.
Syntax
clear counters [{gigabitethernet unit/slot/port | port-channel
number | switchport | tengigabitethernet unit/slot/port }]
Default Configuration
This command has no default configuration.
412
Ethernet Configuration Commands
duplex commands control interface link speeds and auto-
show interfaces
configuration
show interfaces counters
show interfaces description storm-control multicast
show interfaces detail
show statistics
show statistics switchport
show storm-control
shutdown
speed
storm-control broadcast
storm-control unicast
switchport protected
switchport protected name
show switchport protected
–
port-channel-