Arp Aging; Commands In This Chapter - Dell Networking 7048 Reference Manual

ARP Aging

Dynamic entries in the ARP cache are aged. When an entry for a neighbor
router reaches its maximum age, the system sends an ARP request to the
neighbor router to renew the entry. Entries for neighbor routers should
remain in the ARP cache as long as the neighbor continues to respond to ARP
requests. ARP cache entries for neighbor hosts are renewed more selectively.
When an ARP cache entry for a neighbor host reaches its maximum age, the
system checks if the cache entry has been used recently to forward data
traffic. If so, the system sends an ARP request to the entry's target IP address.
If a response is received, the cache entry is retained and its age is reset to 0. By
enabling the dynamic renew option, the system administrator can configure
ARP to attempt to renew aged ARP entries regardless of their use for
forwarding.
If the system learns a new ARP entry but the hardware does not have space to
add the new ARP entry, the system attempts to remove entries that have not
been used for forwarding recently. This action may create space for new
entries in the hardware's ARP table.

Commands in this Chapter

This chapter explains the following commands:
arp
arp cachesize
arp purge
arp resptime
arp retries
arp timeout
arp
Use the arp command in Global Configuration mode to create an Address
Resolution Protocol (ARP) entry. Use the no form of the command to remove
the entry.
892
ARP Commands
clear arp-cache
clear arp-cache management
ip local-proxy-arp
ip proxy-arp
show arp
–