Dell Networking 7048 Reference Manual page 1010

Syntax
ip-address
ip address
no ip address
ip-address — IP address of the interface.
•
subnet-mask — Subnet mask of the interface
•
prefix-length — Length of the prefix. Must be preceded by a forward slash
•
(/). (Range: 1-30 bits)
• secondary — Indicates the IP address is a secondary address.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN, Loopback) mode
User Guidelines
This command also implicitly enables the VLAN or loopback interface for
routing (i.e. as if the user had issued the 'routing' interface command). By
default, configuring an IP address on a VLAN enables in-band management
for interfaces configured with that VLAN. Setting up an IP address on VLAN
1 enables switch management on all in-band interfaces except for those where
VLAN 1 is specifically excluded.
Example
The following example defines the IP address and subnet mask for VLAN 15
and enables the VLAN for routing.
console(config)#interface vlan 15
console(config-if-vlan15)#ip address 192.168.10.10
255.255.255.0
1010
IP Routing Commands
subnet-mask
{
ip-address subnet-mask
{
prefix-length
| } [secondary]
prefix-length
| } [secondary]