Syntax
show ipv6 mld snooping [interface {{gigabitethernet unit/slot/port| port-
port-channel-number | tengigabitethernet unit/slot/port }} | vlan
channel
vlan-id
}]
Default Configuration
This command has no default configuration
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
With no optional arguments, the command displays the following
information:
•
Admin Mode — Indicates whether or not MLD Snooping is active on the
switch.
•
Multicast Control Frame Count— Displays the total number of IGMP or
PIM packets which have been received (same as IPv4).
•
Flooding Unregistered to All Ports—Indicates if Flooding Unregistered to
All Ports is enabled. If enabled, multicast data traffic for which no listeners
have registered is flooded to all ports in a VLAN instead of only flooded to
multicast router ports.
When you specify an interface or VLAN, the following information displays:
•
MLD Snooping Admin Mode — Indicates whether MLD Snooping is
active on the interface or VLAN.
•
Fast Leave Mode — Indicates whether MLD Snooping Fast-leave is active
on the VLAN.
•
Group Membership Interval — Shows the amount of time in seconds that
a switch will wait for a report from a particular group on a particular
interface, which is participating in the VLAN, before deleting the interface
from the entry. This value may be configured.
550
IPv6 MLD Snooping Commands