Ipv6 Traffic-Filter - Dell Networking 7048 Reference Manual

Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(Config)#ipv6 access-list rename DELL_IP6 DELL_IP6_NEW_NAME

ipv6 traffic-filter

The ipv6 traffic-filter command either attaches a specific IPv6 Access
Control List (ACL) to an interface or associates it with a VLAN ID in a given
direction.
An optional sequence number may be specified to indicate the order of this
access list relative to other IPv6 access lists already assigned to this interface
and direction. A lower number indicates higher precedence order. If a
sequence number is already in use for this interface and direction, the
specified IPv6 access list replaces the currently attached IPv6 access list using
that sequence number. If the sequence number is not specified for this
command, a sequence number that is one greater than the highest sequence
number currently in use for this interface and direction is used.
Use the "no" form of the command to remove an IPv6 ACL from the
interface(s) in a given direction.
Syntax
ipv6 traffic-filter
no ipv6 traffic-filter
• name — Alphanumeric string of 1 to 31 characters uniquely identifying
the IPv6 access list.
direction — Direction of the ACL. (Range: in or out)
•
• sequence
already assigned to this interface and direction. (Range: 1–4294967295)
538
IPv6 Access List Commands
name direction
name direction
seq-num — Order of access list relative to other access lists
seq-num
[sequence ]