Deny | Permit (Mac-Access-List-Configuration) - Dell Networking 7048 Reference Manual

Ethertype
0x8809
0x8870
0x888E
0x88CC
0x8906
0x8914
0x9100
deny permit (Mac-Access-List-Configuration)
|
Use the deny command in Mac-Access-List Configuration mode to deny
traffic if the conditions defined in the deny statement are matched. Use the
permit command in Mac-Access-List Configuration mode to allow traffic if
the conditions defined in the permit statement are matched.
Use this command in Mac-Access-List Configuration mode to create a new
rule for the current MAC access list. Each rule is appended to the list of
configured rules for the list.
The command is enhanced to accept the optional time-range parameter. The
time-range parameter allows imposing a time limitation on the MAC ACL
rule as defined by the parameter
specified name does not exist, and the MAC ACL containing this ACL rule is
applied to an interface or bound to a VLAN, then the ACL rule is applied
immediately. If a time range with the specified name exists, and the MAC
ACL containing this ACL rule is applied to an interface or bound to a VLAN,
then the ACL rule is applied when the time-range with a specified name
becomes active. The ACL rule is removed when the time-range with a
specified name becomes inactive.
Syntax
{deny | permit} {{any |
dstmacmask}} [
[[log] [time-range
interface-id
redirect}
296
ACL Commands
Protocol
Slow Protocols (IEEE 802.3)
Jumbo frames
EAP over LAN (EAPOL – 802.1x)
Link Layer Discovery Protocol
Fibre Channel over Ethernet
FCoE Initialization Protocol
Q in Q
srcmac srcmacmask
ethertypekey 0x0600-0xFFFF
|
time-range-name
]
time-range-name
} {any | bpdu |
] vlan {eq
] [assign-queue
. If a time range with the
dstmac
0-4095
}] [cos
queue-id
] [{mirror |
0-7
]