Cisco WS-C6506 Software Manual page 451

Chapter 15 Configuring Access Control
To display a VACL-to-VLAN mapping, perform this task in privileged mode:
Task
Display a VACL-to-VLAN
mapping.
This example shows how to display the mappings of a specific VACL:
Console> (enable) show security acl map IPACL1
ACL IPACL1 is mapped to VLANs:
1
Console> (enable)
This example shows how to display the mappings of a specific VLAN:
Console> (enable) show security acl map 1
VLAN 1 is mapped to IP ACL IPACL1.
VLAN 1 is mapped to IPX ACL IPXACL1.
VLAN 1 is mapped to MAC ACL MACACL1.
Console> (enable)
Clearing the Edit Buffer
You can clear the changes made to the ACL edit buffer since its last save with the rollback command.
The ACL is rolled back to its state at the last commit command.
To clear the ACL edit buffer, perform this task in privileged mode:
Task
Clear the ACL edit buffer.
This example shows how to clear the edit buffer of a specific security ACL:
Console> (enable) rollback security acl IPACL1
Editbuffer for 'IPACL1' rolled back to last commit state.
Console> (enable)
Removing ACEs from Security ACLs
You can remove a specific ACE or all ACEs from an ACL with the clear security acl command. This
command deletes the ACEs from the edit buffer.
To remove an ACE from a security ACL, perform this task in privileged mode:
Task
Remove an ACE from a security ACL. clear security acl all
OL-8978-04
Command
show security acl map {acl_name | vlan | all}
Command
rollback security acl {acl_name | all | adjacency}
Command
clear security acl acl_name
clear security acl acl_name editbuffer_index
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring VACLs
15-55