Network Configuration; Enhancements - Avaya IX Collaboration Unit CU360 Release Notes

Hide thumbs Also See for IX Collaboration Unit CU360:

Installing and administering (145 pages)

Release notes (141 pages)

Manual (98 pages)

Table Of Contents

Table of Contents

• Information: Shows some board information and creates "Information.log". Customer needs to

press Pass button (or Fail button if the information is not available on the screen).

• Onboard Speaker: Touch to enable test tone on onboard speaker and touch again to stop

tone. The customer needs to press Pass button if they can hear tone from endpoint onboard

speakers.

• Bluetooth: Scan and list near devices. Customer to press Pass button if found any, when a

Bluetooth device is nearby.

• SD Card: Insert a microSD card and launch the test. If the test is marked as Pass it closes

automatically

• Light Sensor: Check light sensor, green text shows the value read from sensor on the left on

camera.

• MIC Level Test: Check the audio levels of the embedded mics

• HDMI Speaker: Touch to enable test tone on monitor and touch again to stop tone. The

customer needs to press Pass button if they can hear tone from monitor speakers. Assure that

the volume of the monitor is high enough and the monitor is not muted.

• Wi-fi: Scan and list near wi-fi access points. Customer to press Pass button if found any, when

an access point or hotspot device is nearby.

• USB Host: Insert an USB key and launch the test. If the test is marked as Pass it closes

automatically

• LED: Check LEDs light and color and press Pass button if LEDs light and color correspond to

the choice.

• MIC Audio Test: Record and playback a sample audio content from embedded mics

• Camera: Customer needs to touch the screen and check if camera app work correctly. The first

time the application is launched, the customer must grant the permissions access to camera

app. Press Back button twice to return to result page.

• Lan: Connect a Lan cable and check MAC and IP address. Customer to press Pass button if IP

Address assigned.

• HDMI: The device will display a test image and hide navigation bar after 3 seconds.

• NFC: Use an NFC tag to check. Place the tag over the device camera, in correspondence of

the NFC logo.