Switching Avaya Cu360 On Or Off; Pairing The Remote Control Unit With Avaya Cu360 - Avaya CU360 Installing And Administering

Initial setup and connectivity
• Power adapter
• Rubber cap for camera
Procedure
1. Secure the Avaya CU360 endpoint on an external monitor using the hinge at the bottom of
the endpoint.
2. Connect the HDMI cable in the HDMI ports of Avaya CU360 and the external monitor.
3. Connect the power adapter.

Switching Avaya CU360 on or off

About this task
The power button of Avaya CU360 on the rear of the device. You can use the power button to:
• Switch Avaya CU360 on or off.
• Change the Avaya CU360 mode to standby or wake up the device from the standby mode.
Procedure
Do one of the following:
• To switch Avaya CU360 on or off, press and hold the power button.
• To change the mode of Avaya CU360 to standby or wake up the device from the standby mode,
press the power button.

Pairing the remote control unit with Avaya CU360

Before you begin
Insert two AAA batteries in the remote control unit.
July 2020 Installing and Administering Avaya Collaboration Unit CU360
Comments on this document? infodev@avaya.com
28