Language Settings; Secondary Dial Tone; Page Call Controls - Avaya INDeX 9.1 Programming Manual

INDeX Set up

Language Settings

Secondary Dial Tone

Page Call Controls

Programming Manual
INDeX 9.1
The INDeX supports several languages for use on the display of DT/TT terminals.
You can specify both the INDeX wide default language and the language for an
individual user.
To set the INDeX's default language :
1. From the Administration menu, select System and then Installation.
2. Select Default language to change the current setting.
To set the language used for an individual user :
Display terminal users can change their language setting from the terminal.
1. From the Administration menu, select User and enter the user's directory
number.
2. Select Language to display a list of choices. Select Default to use the INDeX's
default language as set above.
When users start dialling an external call, the call is not connected to an external
line until full ARS processing has taken place. Some locations require that the user
hears secondary dial tone after having dialled the PSTN access digit (see page
18).
To switch secondary dial tone on/off :
1. From the Administration menu, select PSTN Access.
2. Select Secondary dial tone required to switch the current setting between
yes or no.
Normally extension users can answer page calls by pressing their Answer Release
key. On larger INDeXs and INDeXs where network pages are used, this can cause
problems with unintentional page answers.
The INDeX allows the answering of page calls to be switched off if necessary.
To switch page answering on/off :
1. From the Administration menu, select System and then Facility options.
2. Select Answer page to select either yes or no.
Language Settings - Page 17
INDeX Set up - Page 17
38DHB0002UKDJ – Issue 3 (12/00)