Modifying A Release 2.1 Or Earlier; Processor For Permanent Key Mode; Modifying The Processor - Lucent Technologies MERLIN LEGEND Release 6.1 Maintenance And Troubleshooting Manual

MERLIN LEGEND Communications System Release 6.1 MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting 555-661-140
Maintenance and Troubleshooting

Modifying the Processor

Modifying a Release 2.1 or Earlier

E

Processor for Permanent Key Mode

Modifying the Processor
!
CAUTION:
This procedure must be performed for KF registration with the FCC.
This procedure prevents the system from being programmed as a
Hybrid-PBX system. Do this only if the system is programmed for Key
mode and GS trunks are not indicated on Form 2c, System Numbering:
Line/Trunk Jacks.
To modify the processor for Permanent Key mode, follow the steps below. Refer
to Figure E–1.
Remove the processor from its packaging.
Place the processor on a flat surface.
If the feature module is installed, remove it.
See "Replacing the Feature Module" on page 4–32 for instructions.
Issue 1 Issue 1
August 1998 August 1998
Page E-1
E