Lucent Technologies MERLIN LEGEND Release 6.1 Maintenance And Troubleshooting Manual page 37

MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting 555-661-140
Using SPM
Dialing the Modem Directly
To dial the modem directly, follow the steps below.
Start SPM. When the Welcome message appears, press any key.
Enter the command to put the modem in originate mode (this
command varies depending on the type of modem you are using).
Pick up the handset on the T/R telephone and dial the remote
access trunk number.
This is possible only if a trunk is programmed as a dedicated trunk for
remote access to the built-in modem.
If the dial tone begins with three short tones followed by a steady
tone, dial the remote access barrier code from the T/R telephone;
otherwise, go to Step 5.
If you do not know the remote access barrier code, contact the
customer's system manager, or check Form 3a, Incoming Trunks:
Remote Access. If the system accepts the barrier code, you hear ringing
followed by dial tone.
NOTE:
You can change the barrier code without knowing the old one only
when you perform onsite maintenance through the ADMIN jack.
Connect to the modem on the remote system.
When you hear dial tone, dial
When you hear the modem tone, hang up.
If nothing appears on the SPM screen, press
.
Issue 1
August 1998
Page 1-11
.