Channel Loopback Errors - Lucent Technologies MERLIN LEGEND Release 6.1 Maintenance And Troubleshooting Manual

MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting 555-661-140
Module Problems
Table 4–5. Channel Loopback Errors
Error Messages
Any other error
Restoring the Module
When you finish running module tests, be sure to restore the module. See
''Restore'' on page
Replacing Modules
You can remove and insert line/trunk and extension modules (separately or at
the same time) with the system power on without affecting normal call
processing.
Corrective Action
Exit the test, busy-out the slot, and try again.
Exit the test and try again; be sure to type the correct
slot number. Do not indicate an empty slot or the
processor (00).
Exit the test and try again; if this error persists, record
the errors on the repair tag and replace the module
being tested.
Exit the test and try again; if this error persists, record
the errors on the repair tag and replace the module
being tested.
Exit the test and try again; if this error persists, record
the errors on the repair tag and replace the module
being tested.
Record the errors on the repair tag and replace the
module.
4-45.
Issue 1
August 1998
Page 4-61