Lucent Technologies MERLIN LEGEND Release 6.1 Maintenance And Troubleshooting Manual page 72

MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting 555-661-140
Error Logs
Table 2–2. Error Codes (Continued)
Error
Codes Description
Module firmware is not in standby
mode.
Cannot determine module responsible
for generating the interrupt.
Processor problem.
Processor problem.
System was restarted and initialized
to default programming.
This error is also logged after a
System Erase.
Processor problem.
Processor problem.
Physical and logical type mismatch.
Module inserted into wrong slot.
Action
If problem persists, troubleshoot the
module.
If problem persists, troubleshoot the
processor and module.
No action required; however, if problem
persists, troubleshoot the processor.
Troubleshoot modules and replace if
necessary. If the problem persists,
troubleshoot the processor.
Troubleshoot the processor.
Troubleshoot the processor.
If the processor was removed while in
use, the system may perform a frigid start
due to loss of system programming.
Restore system as described in System
Programming and Maintenance (SPM) , or
in Appendix D, "Backing up with a
Memory Card."
Troubleshoot the processor.
Troubleshoot the processor.
Change system programming to reflect
the proper module or install the proper
module.
Continued on next page
Issue 1
August 1998
Page 2-8