Lucent Technologies MERLIN LEGEND Release 6.1 Maintenance And Troubleshooting Manual page 39

MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting 555-661-140
Using SPM
You dial into the system that has public switched network tandem trunks using
Remote Access and then, from that system, reach a private networked switch
using Remote Access again. To dial into the system that has public switched
networked trunks, follow Steps 2–4 in the previous section, "Dialing the Modem
Directly" on page 1–11. If you are already at an extension on a private
networked system, skip these steps. Once you are connected to a system in the
private network, follow the steps below.
Start SPM. When the Welcome message appears, press any key.
Pick up the handset on the T/R telephone and dial the remote
access code.
This is possible only if the remote access code is programmed into the
non-local dial plan of the system from which you are calling.
If the dial tone begins with three short tones followed by a steady
tone, dial the remote access barrier code from the T/R telephone;
otherwise, go to Step 5.
If you do not know the remote access barrier code, contact the
customer's system manager, or check Form 3a, Incoming Trunks:
Remote Access. If the system accepts the barrier code, you hear ringing
followed by dial tone.
NOTE:
You can change the barrier code without knowing the old one only
when you perform onsite maintenance through the ADMIN jack.
Connect to the modem on the remote system.
When you hear dial tone, dial
When you hear the modem tone, hang up.
If nothing appears on the SPM screen, press
.
Issue 1
August 1998
Page 1-13
.