Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 332

Configuring Secure Access Devices Guide
314
Table 94: Device Status Information (continued)
Column Description
Config Status Current configuration status of the device in NSM:
None—No state has been set (does not show in Device Monitor).
Waiting for 1st connect—NSM is waiting for the device to connect. You
must enter a command on the device to make it connect to NSM.
Import Needed—You must import the configuration of the device into
NSM. When you add a device for the first time, verify that your status
indicates "Import Needed" before you attempt to import the device. During
migration, this state indicates that import of the security device
configuration is still required.
OS Version Adjustment Needed—The firmware version detected running
on the device is different than what was previously detected in NSM. This
could happen in the event that the automatic adjustment option was
cleared during a change device firmware directive or an Update Device
directive was issued to an IDP device with a firmware version mismatch.
Platform Mismatch—The device platform selected when adding the DMI
device in NSM does not match the device itself. A device in this state
cannot connect to NSM.
Device Type Mismatch—The type of device specified when adding the
device in NSM does not match the device itself. The device type might
indicate whether the device is part of a vsys device, part of a cluster, or
part of a virtual chassis. A device in this state cannot connect to NSM.
Detected duplicate serial number—The device has the same sequence
number as another managed device. A device in this state cannot connect
to NSM.
Managed—The device is currently being managed by NSM.
Managed, In Sync—The physical device configuration is synced with the
modeled configuration in NSM.
Config Status Managed, Device Changed—The physical device configuration is out of
(continued) sync with the modeled configuration in NSM. Changes were made to the
physical device configuration (the configuration on the physical device is
newer than the modeled configuration).
Managed, NSM Changed—The modeled device configuration is out of
sync with the physical device configuration. Changes were made to the
modeled configuration (the configuration on the NSM is newer than the
physical device configuration).
Managed, NSM and Device Changed—Both device configurations (physical
and modeled) are out of sync with each other. Changes were made to
the physical device configuration and to the modeled configuration.
Managed, Sync Pending—Completion of the Update Device directive is
suspended and waiting for the device to reconnect. This state occurs only
for ScreenOS devices that have the Update When Device Connects option
selected during the device update.
Copyright © 2010, Juniper Networks, Inc.