Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 165

Copyright © 2010, Juniper Networks, Inc.
Table 35: Configuring Telnet and Secure Shell Resource Policy Details
Option Function
Access Control > General tab
Name Specifies the name for the policy.
Description Describes the policy.
Resources Specifies the servers to which this
policy applies.
Applies to Specifies the roles to which this
roles policy applies.
Action Allows or denies access to the
servers specified in the Resources
list.
Role Selections tab
Role Maps roles to the resource policy.
Selections
NOTE: This Roles Selection tab is
enabled only when you select
Selected or the Except the selected
option from the Applies to the role
drop-down list.
Detailed Rules tab
Name Specifies the detailed rule name.
NOTE: This tab is enabled only when
you select Detailed Rules from the
Action drop-down list.
Chapter 10: Configuring Secure Access Resource Policies
Your Action
Enter the name.
Enter the description.
Enter the server path.
Select one of the following options from
the drop-down list:
All—Applies the policy to all users.
Selected—Applies the policy only to
users who are mapped to roles in the
Role Selection section.
Except those selected—Applies the
policy to all users except for those who
mapped to the roles in the Role
Selection section.
Select one of the following options from
the drop-down list.
Allow—Allows access to the servers
specified in the Resources list.
Deny—Denies access to the servers
specified in the Resources list.
Detailed Rules—Allows you to specify
one or more detailed rules for this policy.
Select a role and click Add to add roles
from Non-members to Members list.
Enter a name.
147