Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 183

Copyright © 2010, Juniper Networks, Inc.
Click the Configuration tab and select Authentication > Auth Servers. The
3.
corresponding workspace appears.
NOTE: If you want to update an existing server instance, click the
appropriate link in the Auth Server Name box and perform the Steps 5
through 8.
Click the New button. The New dialog box appears.
4.
Specify a name to identify the server instance.
5.
Select Local Authentication from the Auth Server Type list.
6.
Configure the server using the settings described in Table 41 on page 165.
7.
Click one:
8.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 41: Secure Access Local Authentication Server Instance
Configuration Details
Option Function
Local Auth Settings
Minimum password Specifies the minimum character
length (characters) length for passwords.
Maximum password Specifies the maximum character
length length for passwords.
NOTE: This is optional.
Minimum number of Specifies the minimum number
digits required in the of digits that is required in the
password (digits) password.
Minimum number of Specifies the minimum number
letters required in the of letters that is required in the
password (letters) password.
Require password to Specifies if the password must
have a mix of UPPER contain both uppercase and
and LOWER CASE lowercase letters.
letters
Require password to be Specifies if you want users to set
different from the password to be different from
username the username.
Chapter 11: Configuring Authentication and Directory Servers
Your Action
Set the minimum character length
for passwords.
Set the maximum character length
for passwords.
NOTE: The maximum length
cannot be less than the minimum
length. There is no maximum limit
to the length.
Set the minimum number of digits
that is required in the password.
Set the minimum number of letters
that is required in the password.
Select Local Auth Settings >
Require passwords to have a mix
of UPPER and LOWER CASE
letters to enable this option.
Select Local Auth Settings >
Require password to be different
from username to enable this
option.
165