Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 90

Configuring Secure Access Devices Guide
72
Table 16: User Role Network Connect Configuration Details (continued)
Option
Auto-launch Network Connect
Auto-Uninstall Network
Connect
Enable TOS Bits Copy
Multicast
Install GINA with Network
Connect
GINA Options
Function
Specifies whether or not
Network Connect
automatically launches when
an authenticated usermaps to
one or more roles that enable
Network Connect sessions.
Specifies whether or not
Network Connect uninstalls
itself from the remote client
when a user signs-out of the
Network Connect session.
Specifies that Network
Connect to copy IP TOS bits
from the inner IP packet
header to the outer IP packet
header.
Specifies whether or not you
want Network Connect to
operate in multicast mode.
Additionally installs GINA on a
client system when you install
Network Connect.
Specifies whether or not to
enable GINA installation for a
role and specifies the GINA
sign-in behavior.
Copyright © 2010, Juniper Networks, Inc.
Your Action
preserves the route on the
client, retaining access to
local resources such as
printers.
Select the Auto-Launch
Network Connect check box
to enable this feature.
Select the Auto-Uninstall
Network Connect check box
to enable this feature.
Select the Enable TOS Bits
Copy check box to enable this
feature.
Select the Multicast check box
to enable this feature.
Select the Install GINA with
Network Connect check box
to enable this feature.
Select one of the following
options from the drop-down
list:
Require NC to start when
logging into Windows
(Note that this may require
a reboot when NC is
installed)—Automatically
launches the Network
Connect sign-in function at
every Windows user sign-in.
Allow user to decide
whether to start NC when
logging into
Windows—Allows the user
to determine, at each
Windows startup, whether
or not to launch Network
Connect after GINA
installation.