Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 58

Configuring Secure Access Devices Guide
40
Table 10: Session Options Configuration details
Option
General > Session Options tab
Idle Timeout
Max. Session Length
Reminder Time
Function
Specifies the number of
minutes a nonadministrative
user session may remain idle
before ending. The minimum
is five minutes. The default idle
session limit is 10 minutes,
which means that if a user's
session is inactive for 10
minutes, the Secure Access
device ends the user session
and logs the event in the
system log (unless you enable
session timeout warnings
described later).
Specifies the number of
minutes an active
nonadministrative user session
may remain open before
ending. The minimum is six
minutes. The default time limit
for a user session is 60
minutes, after which the
Secure Access device ends the
user session and logs the
event in the system log. During
an end-user session, prior to
the expiration of the maximum
session length, the Secure
Access device prompts the
user to reenter authentication
credentials, which avoids the
problem of terminating the
user session without warning.
Specifies when the Secure
Access device should prompt
nonadministrative users,
warning them of an impending
session or idle timeout. Specify
in number of minutes before
the timeout is reached.
Copyright © 2010, Juniper Networks, Inc.
Your Action
Enter the session length in
minutes.
Enter the heartbeat interval in
seconds.
Enter the Reminder Time in
minutes.