Applying The Template - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

Configuring Secure Access Devices Guide

Applying the Template

30
Click the Configuration tab; select the required parameters on the left pane and
8.
specify the appropriate values.
Click OK to create a Secure Access device template.
9.
You can now use this template when configuring Secure Access devices.
NOTE: You can create a custom expression in a device template, but you
cannot validate the custom expression. The Validate button is not enabled
in the Custom Expressions editor for device templates.
To apply a template to a Secure Access device:
From the left pane of the NSM UI, click Configure.
1.
Expand Device Manager and select Devices. The Devices workspace appears on the
2.
right side of the screen.
Double-click the Secure Access device to open the device editor.
3.
From the Device Info tab, select Templates. The templates configuration screen
4.
appears.
Click the Edit icon. The Edit Templates dialog box appears.
5.
Select the required template from the list, and click OK in the Edit Templates dialog
6.
box.
In the templates configuration screen, select Retain template values on removal to
7.
retain template values if a template is removed from the device.
Select the required template from the list and apply the required settings as explained
8.
in Table 6 on page 30 and click OK.
Table 6: Template Operations Settings
Option
Add templates with lowest priority
Add templates with highest priority
Remove templates
Don't change templates
Remove conflicting device values
Report irrelevant template values
Report conflicts with other templates
Function
Adds the templates with the least priority.
Adds the templates with the highest priority.
Removes the templates.
Does not accept modifications to the templates.
Does not add device values that conflict.
Reports irrelevant template values.
Reports conflicts with other templates.
Copyright © 2010, Juniper Networks, Inc.