Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 243

Copyright © 2010, Juniper Networks, Inc.
Table 61: Configuring SAML Access Control Resource Policy
Details (continued)
Username Specifies the username that the
Secure Access device must send the
Web service.
NOTE: The username and password
fields are displayed only when you
select the Username/Password
option from the Authentication Type
drop-down list.
Password Specifies the password that the
Secure Access device must send the
Web service.
Certificate Specifies the certificate installed on
the Secure Access device to send to
the Web service.
NOTE: This box is displayed only
when you select Certificate option
from the Authentication Type
drop-down list.
Subject Name Specifies which method the Secure
Type Access device and SAML Web service
should use to identify the user.
Subject Name Specifies the username that the
Secure Access device should pass to
the SAML Web service.
Device Issuer Specifies the hostname of the issuer,
which in most cases is the hostname
of the access management system.
Maximum Specifies the amount of time the
Cache Time Secure Access device should cache
(seconds) the responses (in seconds).
Chapter 14: Configuring Single Sign-On
Enter the username.
Enter the password
Select the certificate installed on the
Secure Access device from the
drop-down list.
Select one of the following options from
the drop-down list:
Other—Sends the username in
another format agreed upon by the
Secure Access device and the SAML
Web service.
DN—Sends the username in the
format of a DN (distinguished name)
attribute.
Email Address—Sends the username
in the format of an e-mail address.
Windows—Sends the username in
the format of a Windows domain
qualified username.
Enter the username.
Enter the hostname.
Enter the time.
225