Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 200

Configuring Secure Access Devices Guide
182
Table 44: Secure Access eTrust SiteMinder Configuration
Details (continued)
Option
Name
Table 45: Secure Access eTrust SiteMinder Advanced Configuration
Details
Option
Siteminder Settings > Advanced tab
Poll Interval (seconds)
Maximum Agents
Maximum Requests/Agent
Idle Timeout (minutes)
Authorize while Authenticating
Function
Specifies the name of the user
attribute cookie in the
SiteMinder user directory.
Function
Specifies the interval at which
Secure Access device polls the
SiteMinder policy server to
check for a new key.
Controls the maximum
number of simultaneous
connections that the Secure
Access device is allowed to
make to the policy server.
NOTE: The default setting is
20.
Controls the maximum
number of requests that the
policy server connection
handles before the Secure
Access device ends the
connection. If necessary, tune
to increase performance.
NOTE: The default setting is
1000.
Controls the maximum
number of minutes a
connection to the policy server
may remain idle (the
connection is not handling
requests) before the Secure
Access device ends the
connection. The default
setting of "none" indicates no
time limit.
Specifies that the Secure
Access device should look up
user attributes on the policy
server immediately after
authentication to determine if
the user is truly authenticated.
Copyright © 2010, Juniper Networks, Inc.
Your Action
Enter a name.
Your Action
Enter the poll interval in
seconds.
Enter a number.
Enter a number.
Enter the Idle timeout in
minutes.
Select Siteminder Settings >
Advanced > Authorize while
Authenticating.