Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 190

Configuring Secure Access Devices Guide
172
In the Auth Server Name list, specify a name for the RADIUS Server.
5.
Select Radius Server from the Auth Server Type list.
6.
Configure the server using the settings described in Table 43 on page 172.
7.
Click one:
8.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 43: RADIUS Server Configuration Details
Option Function
Primary Server tab
Radius Server Specifies a unique name or IP
address for the RADIUS server.
NAS-Identifier Identifies the Secure Access device
network access server client that
communicates with the RADIUS
server.
Authentication Port Specifies the authentication port
value for the RADIUS server.
Shared Secret Specifies a string for the shared
secret.
Accounting Port Specifies the accounting port value
for the RADIUS server.
NAS-IP-Address Controls the NAS IP address value
passed to RADIUS requests.
Timeout (minutes) Specifies the time interval for the
Secure Access device to wait for a
response from the RADIUS server
before timing out the connection.
Retries Allows Secure Access device to try
to make a connection after the first
attempt fails.
Users authenticate Allows you not to submit the
using tokens or password entered by the user to
one-time passwords other SSO enabled applications.
Backup Server tab
Your Action
Enter the name or IP address.
Enter the name.
Enter the port value.
NOTE: Typically this port is
1812, but some legacy servers
might use 1645.
Enter a string for the shared
secret.
Enter the port value.
NOTE: Typically this port is
1813, but some legacy servers
might use 1646.
Enter the NAS IP address.
Enter the time.
Enter the number of retries.
Select Users authenticate
using tokens or one-time
passwords check box.
Copyright © 2010, Juniper Networks, Inc.