Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 336

Configuring Secure Access Devices Guide
Related
Documentation
318
Table 95: Monitoring Secure Access Device as SNMP Agent
Details (continued)
Option Function
Check Frequency Specifies the value for check frequency
(seconds) trap.
Log Capacity (%) Specifies the value for log capacity trap.
Users (%) Specifies the value for users trap.
Memory (%) Specifies the value for memory trap.
Swap Memory (%) Specifies the value for swap memory
trap.
Disk (%) Specifies the value for disk trap.
CPU (%) Specifies the value for CPU trap.
Meeting Users (%) Specifies the value for memory users
trap.
Send Traps for Critical Allows you to send traps for critical log
Log Events events.
Send Traps for Major Allows you to send traps for major log
Log Events events.
SNMP Servers > Host Specifies the server's host name or IP
Name/IP address address
SNMP Servers > Port Specifies the port on which the server
listens.
SNMP Servers > Specifies the community string required
Community by the network management station.
NOTE: To disable the SNMP module, you must disable the SNMP query and
SNMP traps.
Viewing Device Status on page 313
Your Action
Enter the value.
Enter the value.
Enter the value.
Enter the value.
Enter the value.
Enter the value.
Enter the value.
Enter the value.
Select the Send Traps for
Critical Log Events check
box to enable this feature.
Select the Send Traps for
Major Log Events check box
to enable this feature.
Enter the hostname or IP
address.
Enter the port number
(typically port 162.)
Enter the string.
Copyright © 2010, Juniper Networks, Inc.