Configuring Secure Meetings (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

Configuring Secure Meetings (NSM Procedure)

Table 75: Configuring Secure Meeting Details
Option Function
Idle Timeout Specifies the number of minutes a meeting session may
(minutes) remain idle before ending.
Max. Session Length Specifies the number of minutes a meeting session may
(minutes) remain open before ending.
Enable Upload Logs Allows non-Secure Access device users to upload meeting
logs.
Copyright © 2010, Juniper Networks, Inc.
Unlike other access features, Secure Meeting does not have a resource policy. Instead,
you configure system-level settings that apply to all roles for which this feature is enabled.
You can:
Specify session lifetime limits for meetings.
Enable daylight savings adjustments to scheduled meetings.
Specify the maximum color depth of meeting presentations.
Enable automatic email notifications for users who are invited to meetings scheduled
through the Secure Access device end user console.
Define the MySecureMeeting URL.
To configure secure meetings:
In the NSM navigation tree, select Device Manager > Devices. Click the Device Tree
1.
tab, and then double-click the Secure Access device for which you want to configure
secure meetings.
Click the Configuration tab, and select System > Configuration > Secure Meeting.
2.
The corresponding workspace appears.
Add or modify settings as specified in Table 75 on page 259.
3.
Click one:
4.
OK—Saves the changes.
Cancel—Cancels the modification.
Chapter 17: Configuring Secure Access System Management Features
Your Action
Enter the time.
Enter the time.
Select Enable Upload Logs to enable this
feature.
NOTE: If you select the Upload Logs
option, you must also use settings in the
System > Log/Monitoring > Client Logs >
Settings page of the admin console to
enable client-side logging.
259