Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 112

Configuring Secure Access Devices Guide
94
Add or modify settings as specified in Table 21 on page 94.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 21: Configuring JSAM Rosource Profile details
Option Function
Settings tab
Name Specifies a name for the resource
profile.
Description Describes the resource profile.
Type Allows you to select either JSAM or
WSAM to configure resource profile.
Settings tab > JSAM > Custom
Server Hostname or IP Specifies the hostname or IP address
of the remote server.
Server Port Specifies the port on which the
remote server listens for client
connections.
Localhost IP Specifies the IP address of the
localhost.
Client Port Specifies the port on which JSAM
should listen for client application
connections.
Create an access Allows access to the list of servers
control policy allowing specified in the Server Port column
SAM access to these
servers
Allow JSAM to Allows JSAM to select an available
dynamically select an port when the client port you specify
available port if the is taken. The client application must
specified client port is allow you to specify the port number
in use for the connection to use this option.
Settings > Lotus Notes > Autopolicy: SAM Access Control > Rules tab
Name Specifies the name of the policy.
Resources Specifies the application server to
which this policy applies.
Action Allows or denies user access to the
resources.
Your Action
Enter the name.
Enter the description.
Select JSAM option to configure
JSAM resource profile.
Enter the hostname or IP
address.
Enter the port.
Enter the IP address.
Enter the port.
Select the Create an access
control policy allowing SAM
access to these servers check
box to enable this feature.
Select the Allow JSAM to
dynamically select an available
port if the specified client port
is in use check box to enable this
option.
Enter the name.
Enter the application resource
name.
Select either Allow or Deny from
the Action drop–down list.
Copyright © 2010, Juniper Networks, Inc.