Configuring Network Settings; Configuring General Network Settings (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

CHAPTER 18

Configuring Network Settings

Configuring General Network Settings (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring General Network Settings (NSM Procedure) on page 271
Configuring Internal Ports (NSM Procedure) on page 273
Configuring Hosts (NSM Procedure) on page 275
Configuring Internet Protocol Filters (NSM Procedure) on page 276
Configuring general network settings in NSM enables you to view the status of the system
ports, specifies a host name for the Secure Access device, and configures DNS name
resolution, Windows Internet Naming Service (WINS) server, and master browser settings
for the Secure Access device.
To configure general network settings:
In the NSM navigation tree, select Device Manager > Devices. Click the Device Tree
1.
tab, and then double-click the Secure Access device for which you want to configure
general network settings.
Click the Configuration tab, and select System > Network Settings > Overview tab.
2.
The corresponding workspace appears.
Add or modify settings as specified inTable 78 on page 271.
3.
Click one:
4.
OK—Saves the changes.
Cancel—Cancels the modification.
Table 78: Configuring General Network Settings Details
Option Function
General Settings tab
Hostname for Specifies the fully-qualified host name
network identity of the Secure Access device for network
identity.
Your Action
Enter the name of the Secure
Access device.
NOTE: You can enter upto
maximum of 30 characters as
host name.
271