Configuring And Activating The Dmi Agent On The Cluster; Importing Cluster Configuration - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

Configuring and Activating the DMI Agent on the Cluster

Importing Cluster Configuration

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
On each cluster member device, configure and activate the DMI agent and establish an
SSH session with NSM.
After adding the cluster members, you must import the cluster configurations. You do
this only once and for the entire cluster because the configuration is identical for all cluster
members.
To import the cluster configuration:
From the left pane of the NSM UI, click Configure.
1.
Expand Device Manager and select Devices. The Devices workspace appears on the
2.
right side of the screen.
Click the Device Tree tab. Right-click the cluster to which you want to import the
3.
configurations, and select Import Device.
NSM starts to import the configuration and a job window reports the progress of the job.
When the job finishes, the configuration status for each cluster member in the Device
List tab changes from Import Needed to Managed.
After importing, the configuration appears at the cluster level in NSM. To edit the
configuration, open the cluster icon, not the individual cluster members.
Creating and Applying a Secure Access Device Template on page 29
Promoting a Secure Access Device Configuration to a Template on page 31
Adding a Secure Access Cluster Overview on page 23
Chapter 4: Adding Secure Access Clusters
27