Configuring Internet Protocol Filters (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

Configuring Secure Access Devices Guide

Configuring Internet Protocol Filters (NSM Procedure)

Related
Documentation
276
You can configure IP filters in NSM that the Secure Access device can apply to Network
Connect IP pools.
To configure Internet protocol filters:
In the NSM navigation tree, select Device Manager > Devices. Click the Device Tree
1.
tab, and then double-click the Secure Access device for which you want to configure
Internet protocol filters.
Click the Configuration tab, and select System > Network Settings > Network
2.
Connect. The corresponding workspace appears.
Add or modify settings as specified in Table 81 on page 276.
3.
Click one:
4.
OK—Saves the changes.
Cancel—Cancels the modification.
Table 81: Configuring Internet Protocol Filters Details
Option Function
Settings tab
NC Base IP Address Displays the default Network
Connect IP address.
IP Address Filters Specifies the IP address filters.
Managing Large Binary Data Files (NSM Procedure) on page 295
Configuring General Network Settings (NSM Procedure) on page 271
Your Action
Only change the Network Connect server
IP address when instructed to do so by
the Juniper Networks support team.
Enter the IP address filter.
Copyright © 2010, Juniper Networks, Inc.