Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 253

Copyright © 2010, Juniper Networks, Inc.
Click the Configuration tab and select Authentication > Endpoint Security > Host
3.
Checker. The corresponding workspace appears.
Create a new policy or click an existing policy in the Policies section of the page.
4.
Click the tab that corresponds to the operating system for which you want to specify
5.
Host Checker options—Windows, Mac, Linux, Solaris and Windows Mobile. In the
same policy, you can specify different Host Checker requirements for each operating
system.
Add and modify settings as specified inTable 65 on page 235.
6.
Specify the support products or vendors for a system scan check.
7.
Click one:
8.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 65: Configuring Host Checker Third-Party Applications Using
Predefined Rules Details
Option
Predefined Antivirus Rules
Rule Name
Select Products
Require any supported
product from a specific
vendor
Require specific products
Enable Scan period check
Chapter 15: Configuring Secure Access Host Checker Policies
Function
Specifies the name for
Antivirus rule.
Specifies the support
products or vendors for
system scan check.
Checks for any product
(rather than requiring you
to select every product
separately).
Checks for specific
products/vendors to define
compliance by allowing any
product by a specific vendor
(for example, any
Symantec product).
Enables the System scan
for the product.
Your Action
Enter the rule name.
Select one of the following options:
Require any supported
product—Specifies the software
vendor's product that is
supported for the system scan
check.
Require specific
products/Vendors—Specifies
the specific vendor for the
system scan check.
Select the Require any supported
product from a specific vendor to
enable this feature.
Select the Require specific
products to enable this feature.
Select the Enable Scan period
check to enable this feature.
235