Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 290

Configuring Secure Access Devices Guide
Related
Documentation
272
Table 78: Configuring General Network Settings Details (continued)
Option Function
Primary DNS Specifies the primary DNS IP address.
Secondary DNS Specifies the secondary DNS IP address.
New DNS Allows you to specify the default DNS
Domain(s) domain name for the individual Secure
Access device appliance.
WINS Allows you to specify the name or IP
address of a local or remote Windows
Internet Naming Service (WINS) server
that you use to associate workstation
names and locations with IP addresses
(if applicable).
Windows networking tab
Enable network Enables the Secure Access device to
discovery (allows discover shared Windows folders.
detection of
Windows share
folders)
Master Browsers > Allows you to select a WINS server,
Name domain controller, or other server within
the Secure Access device domain that
responds to NETBIOS calls and
associates workstation names and
locations with IP addresses (if
applicable).
Configuring Internal Ports (NSM Procedure) on page 273
Configuring Hosts (NSM Procedure) on page 275
Your Action
Enter the primary DNS IP
address.
Enter the primary DNS IP
address.
Enter a comma delimited list of
DNS domains; The Secure
Access device searches for them
in the order that they are listed.
Enter the name or IP address of
a local or remote WINS.
Select Windows networking tab
> Enable network discovery
(allows detection of Windows
share folders) to enable this
option.
Enter the master browser name.
Copyright © 2010, Juniper Networks, Inc.