Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 245

Copyright © 2010, Juniper Networks, Inc.
Cancel—Cancels the modifications.
Table 62: Configuring SAML SSO Artifact Profile Resource Policy Details
Opton
SAML SSO > General tab or Detailed Role tab
Name
Description
New Resources
Role application
Action
Chapter 14: Configuring Single Sign-On
Function
Specifies the name of the
policy.
Describes the policy.
Specifies the resources to
which this policy applies.
Specifies the roles to which
this policy applies.
Specifies that the Secure
Access device performs a
single-sign on (SSO) request
to the specified URL.
Your Action
Enter the name.
Enter the description.
Enter the path
Select one of the following
options from the drop-down
list:
Policy applies to ALL
roles—Applies the policy to
all users.
Policy applies to SELECTED
roles—Applies the policy
only to users who are
mapped to roles in the Role
Selection section.
Policy applies to all roles
OTHER THAN those
selected below—Applies the
policy to all users except for
those who mapped to the
roles in the Role Selection
section.
Select one of the following
options from the drop-down
list:
Use SAML SSO—Secure
Access device performs a
single-sign on (SSO)
request to the specified URL
using the data specified in
the SAML SSO details
section.
Do not use SAML
SSO—Secure Access device
does not perform an SSO
request.
Use Detailed
Rules—Specifies one or
more detailed rules for this
policy.
227